DC surge protective device, protect against lightning surge voltages in solar system (PV power supply system) These units must be installed in parallel on the DC networks to be protected and provide common and different modes protection. Its installed location are recommended at both ends of the DC power supply line (solar panel side and inverter/converter side), ely if the line routing is external and long High energy Movs equpped with specific thermal disconnectors and related failure indicators .
Technical parameters :
|solar surge protector||WL-PV600||WL -PV1000|
|PV DC specific (IEC 6614-1/EN 61643-11)|
|Pole||2 pole||3 pole|
|Uoc max (V DC)||550||600||800||1000|
|Uc (V DC)||550||600||1000||1000|
|Remote signal contact||Max working volt||250V AC/30V DC||250V AC/30V DC|
|Max working amp 1A (250V/AC)||1A (250V/AC)||1A (250V/AC)|
|1A (30V DC)||1A (30V DC)||1A (30V DC)|
|Wiring & installation|
|Wiring capacity(mm2)||Hard wire||4-25mm||4-25mm|
|Remote signal contact||0.25||0.25|
|Protection class||All profile||IP40||IP40|
|Installation environment||No obvious shock and vibration|
|Altitude(m)||≤ 2000||≤ 2000|
|How to install||Install with H35-7.5/DIN35 stell mounting rail|
Raw Material Parts Display
Surge protector, also name lightning arrestor protector, it's provides safety protection for various electronic equipment, instruments, and communication lines. When an electrical circuit or communication line suddenly generates a peak current or voltage due to external interference, the surge protector can conduct the shunt in a very short time, thereby avoiding the damage of the surge to other equipment in the circuit.
Any requirements or question,welcome to "Send" us an e-mail Now!!!